** Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, nontemperature-controlled environment.
*** The average output across the usable frequency range when applying 1W/1m into the nominal impedance. ie: 2.83 V /8 ohms, 4 V /16 ohms. Eminence response curves are measured under the following conditions: All speakers are tested at 1W/1m using a variety of test set-ups for the appropriate impedance | LMS using 0.25" supplied microphone (software calibrated) mounted 1m from wall/baffle | 2 ft. x 2 ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction | Hafler P1500 Trans-Nova amplifier | 2700 cu. ft. chamber with fiberglass on all six surfaces (three with custom-made wedges).
Bourns PDA24 Potentiometer
HTR-Type, recommended for amps
This specialty potentiometer is commonly used in guitar and bass amplifiers. However, it is also suitable for use in electric guitars and basses. This product is designed with the features most widely requested by amplifier designers.
Set with 5 pcs.
Fender Output Transformer 125A10B / 022923 Push-Pull
for Princeton Reverb, Tweed Deluxe
Pri: 8000 Ohm / CT
Sec: 4, 8, 16 Ohm
Power: 15 Watt
Drehwinkel/Rotation angle: 300°±5°
Kraftaufwand/Rotation torque: 50~350gcm
Leistung/Power rating: 0.25W
Spannung/Voltage rating: 250V
Schalterart/Switch circuit: S.P.S.T.
Schaltleistung/Switch rating: 125VAC, 1A
Lebensdauer/Rotational life: 15,000 cycles
This specialty potentiometer is commonly used in guitar and bass amplifiers.