• Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
• Lap joint construction protection against access of dust and splashing water.
• Unpainted version is vibra finished for a smooth surface with no sharp edges.
• Painted version is painted with tough - satin black polyester - powder paint for a lasting finish, even after machining. Black screws are included to enhance the assembled appearance.
• Four M3.5 x 0.6 x 12 mm long stainless steel, Philips head, machine screws secure lid - into factory tapped holes.
• Designed to meet IP54
• No internal ribs for easy installation of connectors without interference or additional milling.
• Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.

100% Cotton / Baumwolle
Thanks to Hans for the picture ;-)

8", 15 Watts
Voice coil diameter: 1", 25.4mm
Nominal diameter: 8", 203mm
Power Rating: 15W
Nominal impedance: 8Ω
Sensitivity: 93dB
Chassis type: Pressed steel
Voice coil diameter: 1", 25.4mm
Voice coil material: Round copper
Magnet type: Ceramic
Magnet weight: 6oz, 0.17kg
Frequency range: 100-5000Hz
Resonance frequency, Fs: 105Hz
DC resistance, Re: 6.5Ω

Service your poweramps fast and easy: a simple bias-probe for use with any voltage-meter ! Just plug in the bias-probe between the powertube and the tube-socket, messure the idle current and setup the bias - that's all.

To operate this prove a voltage meter is needed, which is not included in the kit.

This probe is for all EL34, 6L6, KT88, 6550 and similar tubes

Degree of difficulty: simple

100% Cotton / Baumwolle